11-20-2022, 12:45 PM
Hi,
I would like to request some instructions on how to seal the dry compartment.
I have the 85x2 o'rings, acrylic tube 300x90x84, and printed the Sl1 and Sl2 parts.
However, I can't figure out where the o'rings should be installed.
Also, what's the mechanism that holds the tube and the printed parts together?
On Sl2 there seem to be holes for 3 internal screws, but I'm not sure of their purpose.
A full CAD, even if a 3D PDF, would be very helpful as well.
Thanks,
ineeve
I would like to request some instructions on how to seal the dry compartment.
I have the 85x2 o'rings, acrylic tube 300x90x84, and printed the Sl1 and Sl2 parts.
However, I can't figure out where the o'rings should be installed.
Also, what's the mechanism that holds the tube and the printed parts together?
On Sl2 there seem to be holes for 3 internal screws, but I'm not sure of their purpose.
A full CAD, even if a 3D PDF, would be very helpful as well.
Thanks,
ineeve